CONDTROL VECTOR 100 Bedienungsanleitung Seite 26

LASER DISTANCE METER
EN
Memory
Short press
Short press
Short press
Short press
Short press
MESSAGE CODES
While operation, the following codes/symbols may appear on the display:
Message Cause
ERR 1 Laser signal is too weak.
ERR 2 Laser signal is too strong.
ERR 3 Low battery.
ERR 4 Failure of memory.
Failure of calculation by
ERR 5
Pythagoras Theorem.
Measuring result exceeds
ERR 6 permissible measuring
range.
ERR 7 Failure of tilt sensor.
26 26
Enter menu of functions.
/ Select function "Memory"
A number of the measurement/calculation result is
reflected in the symbol
/ Flip through saved measurement/calculation results.
Exit the mode.
Vector 100 CONDTROL
on the display.
Solution
Use a reflective plate.
Use a reflective plate.
Charge the battery.
Contact the service center.
Repeat the measurement.
Please change to longer distance
product.
Please contact service center.
User manual