Metabo CODE! Key Bedienungsanleitung Seite 12

02_CODE_Key_ENG
ENGLISH
Changing the code:
You want to replace the old code with a new one. To do so,
you must first delete the old code on the machine - this makes
the machine more "receptive" to the new code. You can then
set the new code and transfer it onto your machine.
Step 1:
Deleting the old code on the machine:
1) If necessary, plug in the machine. The machine must be
switched off.
2) If the machine's old code has not been set already, set it on
the 3 code wheels (7) inside the CODE! key.
3) Hold the CODE! key on the power tool in such a way
(maximum distance: approx. 15 cm) that the sender (5) in
the CODE! key points vertically to the machine's receiver
(4).Ensure it is accurately aligned! See fig. on page 3.
4) Keep the two keys "Close" (1)
simultaneously for at least 3 seconds. Along acoustic
signal will sound if the code has been successfully
transferred onto the machine; 4 short acoustic signals are
given if the code has not been successfully transferred. If this
happens, consult the "Problems, faults" chapter to see how to
remove the fault(s). Repeat the necessary stops in this
chapter to bring the procedure to a successful end.
5) The old code has now been deleted from the machine.
Step 2:
Setting the new code:
See chapter "Setting a new code and transferring it onto the
machine".
12
05.10.2006
and "Open" (2)
14:22 Uhr Seite 12
pressed in