Meec tools 023318 Bedienungsanleitung Seite 35

– Overload protection.
The drill driver switches off without
warning automatically if it is used in
such a way that the power
consumption becomes abnormally
high. If this happens, stop using the
drill driver in this way. Start the drill
driver again.
– Overheating protection.
The drill driver switches off
automatically if it and/or the battery
is overheated. Allow the battery to
cool before starting the drill driver
again.
– Over-discharge protection,
The drill driver switches off
automatically when the battery
capacity is too low. Remove the
battery and charge it with the battery
charger.
Indication of remaining battery
charge
Press the button (A) on the battery to show the
remaining battery capacity. The status lights
(B) go on for a few seconds.
FIG. 4
On Off
Status lights
Flashes
Remaining charge
75% to 100%
50% to 75%
25% to 50%
MAINTENANCE
Wipe the drill driver with a damp cloth.
WARNING!
Switch off the drill driver and remove
the battery before checking, cleaning,
maintenance or adjustments, and before
changing accessories.
NOTE:
Do not use detergent that contains solvent,
or corrosive or abrasive additives.
0% to 25%
Charge the battery.
EN
35