Work Light - Meec Tools 023318 Bedienungsanleitung

2. To fit the battery, align the horns on the
battery to the slots in the casing and press
the battery in place.
3. Press in the battery all the way until it
clicks into place. If the red mark on top of
the button is visible, this indicates that the
battery has not locked into place correctly.
FIG. 2
IMPORTANT:
• Press in the battery all the way.
Otherwise the battery can come loose
and cause personal injury.
• Never attempt to force the battery in
place. If it is not easy to press it in place,
it is not properly aligned.
FITTING / REMOVING BITS
1. Turn the collet anticlockwise to open the
chuck.
2. Push the bit all the way into the chuck.
3. Turn the collet clockwise to tighten the
chuck.
4. Turn the collet anticlockwise to release
the bit.
FITTING / REMOVING HOOK
The hook is used to hang up the drill driver.
It can be fitted on either side.
1. Fit the hook by putting it in the slot on the
preferred side of the casing and lock in
place with the screw.
2. Remove by removing the screw.
FIG. 3
USE
STARTING / STOPPING
1. Press the power switch to start. The speed
increases the more the switch is pressed.
2. Switch off by releasing the power switch.

WORK LIGHT

Press the power switch to switch on the light.
The light goes on when power switch is
pressed. The light goes out about 10 seconds
after releasing the power switch.
WARNING!
Do not look into the beam or point the beam
at the eyes of people or animals.
ROTATION SELECTOR
Press the button to select the direction of
rotation.
IMPORTANT:
• Always check the rotation before use.
• Wait until all moving parts have
completely stopped before changing the
direction of rotation, otherwise this can
damage the drill driver.
• Always put the rotation selector in
neutral when not using the drill driver.
SELECTION OF GEAR
1. Switch off the drill driver.
2. Place the gear selector so that 1 is visible,
for low speed and high torque. Suitable
for heavy pressure.
3. Place the gear selector so that 2 is visible,
for high speed. Suitable for light pressure.
4. Check before starting that the gear
selector is in the correct position for the
required mode.
5. Switch off the drill driver and switch to
gear 1 and continue working if the speed
is reduced a lot when using gear 2.
NOTE:
• Always move the button all the way to
the position for the required gear. The
drill driver can be damaged if it is
started with the selector between
positions.
EN
33