ChiQ BCD-262 Benutzerhandbuch Seite 9

Do not use bristle brush, steel wire brush, detergent, soap powder, alkaline detergent, benzene,
gasoline, acid, hot water and other corrosive or soluble items to cleanse the cabinet surface, door gasket,
plastic decorative parts, etc., so as to avoid damage.
Carefully wipe dry the door gasket, clean the groove using a wooden chopstick wrapped with cotton string.
After the cleaning, fix the four corners of the door gasket first, and then embed it segment by segment into
the door groove.
Interruption of power supply or failure of the refrigerating system
Take care of the frozen foods in the event of an extended non-running of the refrigerating appliance
•
(such as interruption of power supply or failure of the refrigerating system).
Try to open the refrigerator door as less as possible, in this way can food safely and freshly kept for
•
hours even in hot summer.
If you get the power outage notice in advance：
•
Adjust the thermostat knob to the high mode an hour in advance, so that foods get fully frozen
o
(Do not store new food during this time!). Restore the temperature mode to the original setting
when power supply becomes normal in a timely manner.
You can also make ice with a watertight container and put it in the upper part of the freezer, so
o
as to extend the time for fresh food to be stored.
Note: Once the refrigerator is used, you'd better use it continuously; and under normal circumstance,
do not stop its use, so as not to affect the service life.
Defrosting
After a period of use, a thin layer of frost will be formed on the freezer compartment inner wall (or
evaporator) surface, which may affect the refrigeration effect if exceeding 5mm in thickness. In such case,
you need to gently scrape the frost off using an ice scraper rather than the metal or sharp hardware. Frosts
need to be cleared off every 3 months or so, and if the normal use of drawers and normal access of foods
are affected by frosting, make sure to remove the frosts in a timely manner. Follow the following steps to
remove frosts:
Take out the frozen foods, shut off the mains power supply, open the refrigerator door, and gently
•
remove the frosts from the inner wall with an ice scraper. To speed up the thawing process, you are
suggested to place a bowl of hot water inside the refrigerator/freezer, and when the solid ice frosts
become loose, use an ice scraper to scrape them off and then take them out.
After defrosting, clean the refrigerator/freezer inside, and switch on the power supply.
•
Changing the lamp
The LED lamp is used by the refrigerator for lighting, which features low energy consumption and long
service life. In case of any abnormality, please contact the after-sales personnel for visiting service. The
lamps can only be replaced by the manufacturer, together with a part of the appliance.
Lamp type: LED light
Energy efficiency level: F
Safety-check after maintenance
Is the power cord broken or damaged?
•
Is the power plug firmly inserted into the socket?
•
Is the power plug abnormally overheating?
•
Note: Electric shock and fire accident may be caused in case the power cord and plugs damaged or
stained by dust. If any abnormality, please unplug the power plug and get in contact with the vendor.
9