Use; Gas Leaks; Electric Heating - Qlima Gh 3062 Rf Hybrid Benutzerhandbuch

USE

The knobs for turning the gas heater ON are located on the upper part of the heater:
• Open the gas container (follow the user instructions provided with the low-pressure regulator).
• Press down the ignitor button for 10-25 seconds
• After 10-25 seconds: turn button 90 degrees anti clockwise to start ignition
• Keep the button pushed down
• When the flame is stable for 10-15 seconds: turn the knob to higher capacity if necessary.
o If flame is extinguished: go back to step 1 and 2. But press down button for 30-40 seconds before turning 90 degrees
o Release knob until flame is stable for 20-30 seconds
• Never push down the ignitor button for more than 40 seconds
If the heater does not want to ignite:
Check whether gas heater is full and give the gas cylinder a good shake (do not turn up side down!)
If sure that gas heater is full: Take the heater, your regulator and your gas cylinder to outside.
• Check and clean the filter of the regulator – remove all dirt and particles
• Release a little bit of gas (outdoors!) from the gas container. This will clear present dirt particles to prevent them from entering the pressure
regulator or device.
NEVER move the heater when it is hot and/or in operation!
To turn OFF the heater:
1. Turn the knob to position 0
2. Close the gas cylinder valve
3. Check that all flames are extinguished

GAS LEAKS

If you think there may be a gas leak, please follow this procedure:
• Close the gas container valve. (follow the user instructions for the regulator);
• Extinguish all open flames, for instance stoves;
• Open windows in order to increase airflow circulation;
• Turn off electrical devices, for instance lamps;
• Prepare a bucket of soapy water;
• Open the gas container (follow the user instructions for the regulator);
• Brush the soapy water on all fittings and connections of the gas circuit;
• If there is a gas leak, bubbles will rise up from the location of the leak;
• If a leak is found, close the gas container (follow the user instructions for the regulator).
• Tighten the fitting and the metal rings of the connection;
• Open the gas container (follow the user instructions for the regulator) and repeat the procedure again.
If there is still a gas leak contact a professional and qualified engineer for help.
ELECTRIC HEATING (GH3062RF HYBRID)
The electric heating system is designed for infrared radiation technology. Even if used in an unsealed large room the efficiency will be perfect.
There is a switch to select Gas or Electric heating. The heater has two heating elements, which can be used separately or together depending
on the need.
Operation:
a. Make sure that the plug is normally earthed. Put the plug into the socket.
b. Press switch "Fan" to get ready to use the heater and to start the fan.
c. Press switch "I" to start electric heating with half effect.
d. Press the other switch "I" to start electric heating with maximum effect if needed.
e. Turn OFF all switches after use. Remove the plug from the socket.
b c d
* turn thermostat to "High": electric heater will work to high room temperature
* turn thermostat to "Low": electric heater will switch off at lowest room temperature and will restart automatically when this lowest room
temperature is undercut
4
34
man_GH3042R-GH3062RF ('19) V1.indd 34 18-06-19 15:19