Briggs & Stratton 1695856 Bedienungsanleitung Seite 14

Stopping the Snowthrower
1. Release the auger control lever (A, Figure 3).
2. Release the traction control lever (F).
3. Stop the engine. Please refer to the engine operator's
manual for engine instructions.
Easy Turn™ Traction Control (if
equipped)
For easy turning when using the snowthrower, squeeze the
Easy Turn traction control lever (Figure 4).
NOTE: Some models feature Easy Turn traction control for
one wheel only, while other models feature it for both wheels.
NOTE: Easy Turn traction control will be more difficult to acti-
vate under a heavy load. Activate the lever before beginning
a turn.
Engaging the Easy Turn traction control lever releases one
of the traction wheels, but allows the other wheel to continue
driving. Releasing the Easy Turn traction control lever auto-
matically engages both drive wheels for full traction (Figure
5).
Wheel Release - Lock Knob (if
equipped)
Some models are equipped with a drive wheel release that
allows you to disengage one of the drive wheels, for easier
transporting of the unit with the engine off.
Models with Traction Lock Knob: Wheels equipped with a
traction lock knob (A, Figure 6) can be completely released
by pulling the knob out away from the wheel until the locking
pin is disengaged from the wheel. Then rotate the knob so
the pin does not re-engage the wheel. Reverse this process
to engage the drive wheel.
Wheel Release - Lock Pins (if equipped)
Wheels equipped with a traction lock pin (A, Figure 7) can be
completely released by removing the pin and installing it in
the outer axle hole. Reverse this process to engage the drive
wheel.
14
All manuals and user guides at all-guides.com
Deflector Adjustment
A. Manual Deflector Control (if equipped)
Loosen the deflector knob (A, Figure 8), adjust the deflector
to the desired position, and then tighten the knob to secure.
Raise the deflector to throw snow further.
B. Electric Deflector Control (if equipped)
While the engine is running, press either side of the deflec-
tor control switch (B, Figure 8) to move the deflector up and
down. Raise the deflector to throw snow further.
C. In-Dash Deflector Control (if equipped)
Move the deflector control lever (C, Figure 8) forward or
backward to raise and lower the deflector. Raise the deflector
to throw snow further.
Chute Rotation Adjustment
A. Electric Chute Rotation Control (if equipped)
While the engine is running, press either side of the chute
rotation switch (A, Figure 9) to rotate the chute left or right.
B. In-Dash Chute Rotation Control (if equipped)
Locate the in-dash chute rotation crank (B, Figure 9). Rotate
the crank to rotate the chute.
C. Lefthand Crank Chute Rotation Control (if
equipped)
Locate the lefthand chute rotation crank (C, Figure 9) Rotate
the crank to rotate the chute.
Filling the Fuel Tank
Please refer to the engine operator's manual for information
about filling the fuel tank, and for fuel recommendations.