Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To verify the good combustion of the stove, check that the combustion gas that escaped from the chimney is
transparent. If it is white, it means that the stove is not regulated correctly or the wood is too wet. If, however, it is grey
or black, it is a sign that combustion is not complete.
Max feed quantity ( kg /h)
Air Register ( R ) (Picture 1)
11. FUNCTIONING IN THE TRANSITION PERIOD
During the transition period, i.e. when the external temperatures are higher, if the temperature should increase
suddenly there may be problems in the flue, meaning that the combustion gases are not sucked up completely. The
exhaust gases no longer escape completely (strong smell of gas).
In this case, shake the grate more frequently and increase the air for combustion. Successively, feed a reduced
amount of fuel, so that this burns quicker (with the development of flames) and therefore stabilises draught in the flue.
Check that all openings for cleaning and connections to the chimney are hermetic.
12. PELLET FEEDING
ATTENTION: The pellet feeding operations can be performed with the stove on or off. Do not allow the bag of
pellets to come into contact with the boiling hot stove during the filling phase
1)
Open the lateral access door to the mechanical parts ( L Picture 11);
2)
Check the correct positioning in lever A in position 2 (Picture 11); ATTENTION:
with the knob moved towards the front of the stove, position 1, it is impossible to
open the tank lid.
3)
Release the handle of the pellet tank lid B Picture 11;
4)
Open the tank lid (S);
5)
On opening the tank lid, there is a compartment with a capacity equal to about 5
kg, where the pellets must be inserted;
6)
pour in the pellets;
7)
at this point, close the tank lid (S) lock it using the handle (B) to make sure it is
hermetic.
8)
Press point C Picture 11 slightly to allow movement of knob A in the direction
indicated by the arrow (position 1): in this way the pellets in the compartment will
descend into the tank;
9)
Once the pellet has descended. take the knob A to its original position (position
2). IMPORTANT: with the tank completely full, due to the possible presence of
pellet, it may not be possible to take lever A into position 2. This does not
jeopardise the good functioning of the stove. After part of the fuel has been
consumed, the lever A can be taken back to position 2.
To fill the tank to maximum capacity just repeat the points from number 2) to number
9) four times (the tank has a total capacity of about 20 kg).
ATTENTION: Once the feeding procedure has ended, the stove must be as in
the original state, i.e. with the side door ( L ) and the tank lid closed (S) using the handle. The
bags of pellets must be kept at least 1.5 metres from the stove.
13. SWITCH-OFF
13.1. WOOD SWITCH-OFF
By interrupting the feeding of wood, the stove goes out naturally.
To light the stove again, follow the indications given in the chapter 9.1.
13.2. PELLET SWITCH-OFF
The stove is supplied with a system that interrupts pellet supply to the burner ( B ):
Using the WOOD-PELLET switch-over lever in the "L-W-H" position(Picture 8 pos.C) it is possible to block the natural
sliding of the pellet into the burner.
30
FUEL
WOOD
1.8
MIN
CLEO COMBI
PELLET
(diameter 6mm)
2
MAX
A
B
A
2
1
Picture 11
8192000 Rev.04 – EN
L
C
Werbung
Inhaltsverzeichnis
