Werbung
REMOVAL OF ROTATION HEAD
For easier mounting of the rotation head afterwards, turn
1)
2)
REMOVAL OF HEADSUPPORT
>
+
y)
Ey)
»
OR
y
GPE
the head to "normal direction" (tape guiding on the right
side) before removing:
Press DIRECTION - key once.
Turn flywheel by hand as long as head turns around.
Then continue for about half a rotation of the flywheel
till you hear a mechanical click. Now the mechanism is
released.
Release compression spring by pressing locklug aside.
Pull the spring about half of the spring length out.
Press locklugs of the headsupport aside.
Pull headsupport in direction to the keys and lift it.
MOUNTING OF ROTATION HEAD
Rack pos.81 has to be aligned before mounting the rotation
head:
1)
Press DIRECTION - key once.
Turn flywheel by hand as long as the alignment pin of
rack pos.81
is in line with the alignment marking on
the headsupport --> see sketch.
2)
Hold the head in normal (horizontal) position - marking
on the head is on top.
3)
Snap head into headsupport.
remark: If you follow the above instruction the teeth of
the gear will fit together.
4)
Change the direction as described under "removal! of
rotation head" and check if the rotation head turns to
the correct position.
If the head is not in horizontal position repeat and take
care of exact alignment of rack pos.81 and horizontal
position of the head while mounting.
MOUNTING
OF HEADSUPPORT
3) e.g. precision
screwdriver size 1.4mm
Feed hook on the rear of the headsupport into the
chassis first. Then lower the front part to the chassis
and press headsupport
towards
back until locklugs
snap in.
Attention: In case of a reverse deck take care of fitting
the pinch roller pressing springs correctly
into the guiding slots of the chassis.
2)
Use a little screwdriver
as a guiding and compress
compression spring until locklug arrests.
CS 48 606
Werbung
