Zanussi ZDI16001 Benutzerinformation Seite 26

Problem
Limescale particles on the
dishes.
Whitish streaks and stains or
bluish layers on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.
Activating the rinse aid dispenser with the multitab
function activated
1. Press the on/off button to activate the appliance. The
on/off indicator comes on.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators above function buttons
(A), (B) and (C) flash.
4. Press function button (B) .
26
Possible cause
There was no detergent in the detergent
dispenser.
The salt container is empty.
The set level of the water softener is in-
correct.
The cap of the salt container is loose.
The released quantity of rinse aid is too
much.
The quantity of detergent was too much.
The released quantity of rinse aid was
not sufficient .
The quality of the detergent can be the
cause.
• The programme had no drying phase.
• The programme had a low tempera-
ture drying phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent tab-
lets can be the cause.
Make sure that you add detergent in the
dispenser before you start a programme.
Make sure that there is dishwasher salt in
the salt container.
Make sure that the set level of the water
softener agrees with the water hardness in
your area.
Tighten the cap.
Decrease the released quantity of rinse aid
.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Increase the released quantity of rinse aid.
Try a different brand of detergent.
For better drying results, keep the door
ajar for some minutes.
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
• The indicators above function buttons (A) and (C)
go off.
• The indicator above function button (B) continues
to flash.
• The display shows the setting of the rinse aid dis-
penser.
5. Press function button (B) to change the setting.
Possible solution
Off
On