Zanussi ZDI16001 Benutzerinformation Seite 22

Using the detergent
Caution! Use only detergents for dishwashers.
Do not use more than the correct quantity of deter-
gent. Refer to the instructions on the detergent
packaging.
1
A
3
Put the detergent or the
tablet in compartment (A).
B
If the programme has a
prewash phase, put a
small quantity of detergent
in compartment (B).
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on the
dishes.
We recommend that you use detergent tablets with long
programmes.
22
2
A
4
Setting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• The indicators of the 2 programme buttons come on.
• The display shows 2 horizontal status bars.
If the control panel shows other conditions, press and
hold function buttons (B) and (C) at the same time until
the appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. To set a programme, keep the appliance door ajar.
3. Press the on/off button to activate the appliance. The
on/off indicator comes on.
4. Make sure that the appliance is in setting mode.
5. Press one of the programme buttons again and again
until the number of the programme you want to set
flashes in the display.
• The phase indicators of the set programme flash.
6. Close the appliance door. The programme starts.
• The display shows the programme duration that
decreases with steps of 1 minute.
• The indicator of the phase in operation is on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until the dis-
play shows the delay time you want to set (from 1 to
19 hours).
• The delay time flashes in the display.
• The delay indicator comes on.
3. Close the appliance door. The countdown starts.
• The display shows the countdown of the delay
start that decreases with steps of 1 hour.
• The phase indicators of the set programme go off.
• When the countdown is completed, the programme
starts.
– The delay indicator goes off.
– The indicator of the phase in operation comes on.
– The display shows the programme duration.