Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press the multitab button, the multitab indicator
comes on.
The function stays on until you deactivate it. Press
the multitab button, the multitab indicator goes off.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse aid and dishwasher
salt, do these steps:
1. Deactivate the multitab function.
Before first use
1. Make sure that the set level of the water softener
agrees with the water hardness in your area. If not,
adjust the water softener. Contact your local water au-
thority to know the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appliance. Start a
programme to remove them. Do not use detergent
and do not load the baskets.
If you use the combi detergent tablets, activate the
multitab function. These tablets contain detergent,
rinse aid and other added agents. Be sure that these tab-
German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
Water hardness
French
mmol/l
degrees
(°fH)
91 - 125
9.1 - 12.5
76 - 90
7.6 - 9.0
65 - 75
6.5 - 7.5
51 - 64
5.1 - 6.4
40 - 50
4.0 - 5.0
33 - 39
3.3 - 3.9
26 - 32
2.6 - 3.2
19 - 25
1.9 - 2.5
7 - 18
0.7 - 1.8
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the shortest programme with a rinsing phase,
without detergent and without dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
lets are applicable to the water hardness in your area. Re-
fer to the instructions on the packaging of the products.
Adjusting the water softener
Hard water contains a high quantity of minerals that can
cause damage to the appliance and bad washing results.
The water softener neutralises these minerals.
The dishwasher salt keeps the water softener clean and in
good conditions. Refer to the table to adjust the water
softener to the right level. It makes sure that the water
softener uses the correct quantity of dishwasher salt and
water.
You must adjust the water softener manually and
electronically.
Clarke
degrees
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
Water softener
adjustment
Manual
Electronic
10
1)
2
9
1)
2
8
1)
2
7
1)
2
6
1)
2
1)
1)
2
5
1
4
1
3
1
2
19
Werbung
