Zanussi ZDI16001 Benutzerinformation Seite 25

Problem
The appliance does not fill
with water.
The appliance does not drain
the water.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Service.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Possible cause
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is lime-
scale on it.
The filter in the water inlet hose is clog-
ged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
The filters are not correctly assembled
and installed.
The spray arms are clogged.
The programme was not applicable for
the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all items.
The spray arms could not turn freely.
The quantity of detergent was not suffi-
cient.
Cancel the delay start or wait for the end
of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the hose is
correct.
Close the water tap and contact the Serv-
ice.
Clean the sink spigot.
Make sure that the position of the hose is
correct.
If the display shows other alarm codes, contact the Serv-
ice.
Clean the filters.
Make sure that the filters are correctly as-
sembled and installed.
Remove remaining soil with a thin pointed
object.
Make sure that the programme is applica-
ble for the type of load and soil.
Make sure that the position of the items in
the baskets is correct and that the water
can easily wash all items.
Make sure that the position of the items in
the baskets is correct and does not cause
the blockage of the spray arms.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Possible solution
Possible solution
25