Options; Before First Use - Zanussi ZDI16001 Benutzerinformation

1)
Programme
7
Plate warmer
6)
1) The display shows the programme duration.
The water pressure and temperature, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and
bad odours to come out from the appliance.
Do not use detergent with this programme.
3) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the
temperature and quantity of the water, the energy consumption and the programme duration.
4) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
5) This is the standard programme for test institutes. With this programme you have the most efficient use of
water and energy consumption for crockery and cutlery with normal soil. Refer to the supplied leaflet for test
information.
6) This programme makes the dishes warm before use or removes the dust from dishes not used for a long
time.
Do not use detergent with this programme.

Options

Multitab option
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse aid and
salt. The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab function
before the start of a programme. You can-
not activate or deactivate this function while a
programme operates.
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
2. Press the multitab button, the multitab indi-
cator comes on.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
20
Degree of soil
Type of load
Rinse 70 °C
Programme phases
The function stays on until you deactivate
it. Press the multitab button, the multitab
indicator goes off.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
Energy Water
(kWh) (l)
0,8 4
www.zanussi.com