SUHNER ABRASIVE BSG 10 Originalbetriebsanleitung Seite 18

1. N
1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the hand tool BSG
10.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The hand tool is designed for dry applications on metal
surfaces. This takes grinding belts for grinding, satin fin-
ishing, matting, patterning, polishing, and smoothing.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Suhner Schweiz AG of Industriestrasse
10, CH-5242 Lupfig, hereby declares for the partly com-
pleted machinery (see reverse side for type and serial no.)
that the following fundamental requirements of the Direc-
tive 2006/42/EC are applied and fulfilled in accordance
with Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1,
1.5.1, 1.5.4, and 1.6.1. Technical documentation was gen-
erated for the partly completed machinery in accordance
with Annex VII of the Machinery Directive. Document
Agent: T. Fischer. Authorised sites are provided with this
technical documentation in paper or electronic form on
justified request. This partly completed machinery may
be put into operation only when the machine in which the
partly completed machinery is to be incorporated has
been ascertained to fulfil the conditions under the Ma-
chinery Directive. CH-Lupfig, 10/2019. T. Fischer/Division
manager
2. C
2.1 A
ssemBly instructiOns
hand tools.
Use only hand tools, shafts, and grinding tools in perfect
condition.
Attach the hand tool to the shaft only when the drive is
switched off and has come to a stop.
Connect grinding tools only when the drive is switched off
18
S
oTES oN aFETy
ommISSIoNINg
It is imperative that you
read Sections 2 and 3 be-
fore you start operating the
and has come to a stop.
It is imperative that you use the guards intended for the
hand tool.
Observe the specifications applying to your country.
2.1.1 A /
ttAching detAching the hAnd tOOl
Press the locking button and insert the hose coupling into
the hand tool hole. Make sure that the locking button is
engaged. Follow these instructions in reverse order to de-
tach the hand tool.
2.1.2 Attaching/detaching the belt grinding tool, the
contact rollers, and the grinding belt
Place the contact rollers on the spindle. Put on the wash-
ers and screw on the nuts. Hold the contact rollers firmly
and tighten the nuts with assembly tools.
Follow these instructions in reverse order to detach the
contact roller.
Use the setscrew to align the adjustable contact roller
parallel to the fixed contact roller. Hold firmly the hand tool
at the handle and press the spring loaded head piece flat
against a firm surface. Centre the grinding belt over the