Husqvarna 325iRJ Bedienungsanweisung Seite 16

• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows. Do not place loop handle or suspension ring
on label. (Fig. 29)
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the J-handle
WARNING:
with the J-handle.
1. Attach the J-handle to the loop handle with 3 screws.
Do not tighten the screws fully. (Fig. 30)
2. Adjust the product to a comfortable position.
3. Tighten the screws. (Fig. 31)
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
on page 21 .
WARNING:
cutting attachment can result in injury or
death.
16
Assembly
Do not use saw blades
Use protective gloves.
Always use the cutting
Technical data
An incorrectly attached
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
Cutting equipment and guards
The product uses the same cutting attachment guard for
the grass blade and the trimmer head.
• Cutting attachment guard and grass blade.
(Fig. 32)
• Cutting attachment guard and trimmer head.
(Fig. 33)
Assembly of the trimmer head, the
cutting attachment guard and the grass
blade
To attach the trimmer head
1. Put the drive disc (B) on the output shaft.
2. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Turn the trimmer head (H) counterclockwise to
attach. (Fig. 34)
To remove the trimmer head
1. Put the locking pin (C) in the hole to lock the shaft.
2. Turn the trimmer head (H) clockwise to remove it.
3. Remove the drive disc (B) from the output shaft.
(Fig. 34)
To attach the cutting attachment guard
1. Attach the cutting attachment guard (A) to the hook
on the plate holder (B). (Fig. 35)
2. Install the cutting attachment guard on the shaft and
tighten it with the bolt (C).
To remove the cutting attachment guard
• Loosen the bolt (C) and remove the cutting
attachment guard (A) from the shaft. (Fig. 36)
To attach the grass blade
1. Put the gear of the product on a flat surface to make
sure that the blade is assembled correctly.
1858 - 005 - 05.10.2023