Weller WR 2 Originalbetriebsanleitung Seite 47

Parameter menu
Standby Temp. (STANDBY)
After activating the Setback function or after pushing the ECO button (WR 2), the temperature is automa-
tically reduced to Standby temperature. The display 昀氀ashes the actual temperature. <STANDBY appears
on the display.
Setback time (SETBACK)
If the soldering tool is not in use, the temperature
is reduced to Standby temperature on expiration of
the preset Setback time.
SETBACK appears on the display.
To exit Standby mode, push the „UP / DOWN"
buttons or ECO (WR 2).
Depending on the tool in use, the 昀椀nger switch or
the safety rest deactivates Standby mode.
AUTO OFF time (automatic switch-off time)
If the soldering tool is not in use, the soldering tool
is switched off on expiration of the AUTO-OFF
time.
The actual temperature 昀氀ashes on the display and
serves as residual-heat indicator. „OFF" appears
on the display. A 昀氀ashing dash appears on the
display below 50 °C (122 °F).
Temperature-Offset (Offset)
The actual soldering-tip temperature can be adapted by entering a temperature offset around ± 40 °C (±
72 °F).
Temperature window (WINDOW)
Starting from a set, locked temperature, it is possible to set a temperature window of ± 1-99 °C (±1-180
°F) using the WINDOW function. To use the WINDOW function, the repair station must be interlocked.
Temperature units (°C/°F)
Option Description
° C Celsius
° F Fahrenheit
Option Description
0 min Deactivated (Default setting)
ON After placing the soldering iron into
the safety rest, the temperature is
immediately reduced to standby
level.
1-999 min Setback time Individually adjustable
Option Description
0 min Deactivated (Default setting)
1-999 min AUTO-OFF time, can be set indivi-
dually.
- 1 -
Menu access
Menu access - 1 -
Menu access - 1 -
Menu access - 1 -
Menu access - 1 -
Menu access - 1 -
47