Error Messages And Error Clearance - Weller WR 2 Originalbetriebsanleitung

Technical Data

Error messages and error clearance

Message/symptom
Display: „- - -
No display function (display
OFF)
No vacuum at desoldering tool
Insuf昀椀cient vacuum at desolde-
ring tool
Hot air tool has no air
Possible cause
„
Tool has not been detected
„ Tool defective
No mains supply voltage
„
„
Vakuum nicht angeschlossen
„
Desoldering nozzle clogged
Pump faulty
„
„
Filter cartridge on desoldering
tool full
Main 昀椀lter full
„
„
Air hose not connected
Main 昀椀lter full
„
Remedial measures
„
Check connection of tool to
device
„
Check connected tool
„
Turn on mains power switch
Check mains supply voltage
„
„
Check device fuse
„
Connect vacuum hose to
vacuum connection
„
Service desoldering nozzle
using cleaning tool
Change 昀椀lter cartridge on
„
desoldering tool full
Change the main 昀椀lter element
„
on the soldering station
„
Connect or check air hose
Change the main 昀椀lter element
„
on the soldering station
53