Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.2 Confirmation of cartridge replacement
The following appears on the display (Fig. 10.2)
When all settings have been made and saved, the new calculated
remaining quantity [litres] is displayed.
IMPORTANT: After each cartridge change, items 6. RAW WATER
HARDNESS, 7. CARTRIDGE, 8. SOFT WATER HARDNESS must be
set again.
11.
ADJUSTMENT OF HWE
Set the desired mixed water hardness on the blending valve as shown
(fig. 11)
Turn towards „SOFT" = soft water
Turn towards „HARD" = harder water
12.
ADJUSTMENT OF HVE
Deactivating the blending valve:
Turn the spindle completely in with an Allen key,
clockwise, as shown (Fig. 12).
Fix / hold the outer ring (with the embossed
indicator arrow) as shown (Fig. 12).
Determination of the output quality with a conductivity meter:
Remove treated water from the drain valve and measure or check its conductivity (< 100 µs). The
specifications according to VDI 2035/I must be observed.
IMPORTANT: When the blending valve is closed, no more raw water is added!
The system can be filled after an inspection.
13.
TECHNICAL DATA
Table Technical Data
Medium
Max. operating pressure
Operating temperature max.
Flow capacity from 4 litre cartridge
Flow capacity with 2.5 litre cartridge
Digitale Kapazitäts-Kontrolle
Fig. 11
Fig. 12
Potable water
6.0 bar
30.0 °C
0.5 m³/h
0.3 m³/h
13
OK
Fig. 10.2
e
e
r o l l
r o l l
o n t
o n t
t s - K
t s - K
z i t ä
z i t ä
a p a
a p a
e K
e K
i t a l
i t a l
O K
O K
D i g
D i g
r o l l
r o l l
e
e
o n t
o n t
t s - K
t s - K
z i t ä
z i t ä
a p a
a p a
e K
e K
i t a l
i t a l
O K
O K
D i g
D i g
Werbung
