To Remove And Sharpen The Blade; Storage; Transport; Disposal - Meec tools 024998 Bedienungsanleitung/Übersetzung Der Originalanleitung

6.3 To remove and sharpen the blade

Warning! Remove the battery from the mower before
servicing or cleaning.
When the blade becomes blunt it should be removed and
sharpened.
1
Undo the nut holding the blade. (Figure 12)
2
Release the blade and carefully clean the contact
surfaces. If the blade is very worn it should be
replaced with a new one.
3
Sharpen the blade.
4
Fit the blade on the lawn mower and firmly tighten
the nut.
5
Only use spare parts recommended by the
manufacturer.
7

Storage

Warning! Remove the safety key before putting into
storage.
Caution! Never let brake fluid, petrol, oil-based
products, penetrating oils, etc. come into contact with
plastic parts.
● Store the lawn mower in a dry place and frost-free
(10–25°C).
● Store the battery and lawn mower separately.
● Charge the battery before putting into storage if it is not
going to be used for some time.
● Store the lawn mower away from corrosive substances,
such as salt and fertiliser.
8

Transport

Warning! Remove the battery from lawn mower
before transport.
1
Undo the two quick-couplings and fold down the top
handle.
2
Use the carry handle to transport the lawn mower.
9

Disposal

9.1

To discard the product

● Make sure that you follow local regulations when you
discard the product. Do not burn the product.

10 Technical data

Specification
Rated voltage
Battery capacity
Battery type
Speed
Protection rating
Cutting width
Catcher
Height adjustment
Weight
Sound pressure level, LpA
Measured sound power level,
LwA
Guaranteed sound power level,
LwA
Vibration level
1
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level when
using tools may differ from the specified maximum value,
depending on how the tool is used and the material. It is
therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of
exposure in actual operating conditions (taking into account
all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up
time).
1 The declared values for vibration and noise, which have
been measured according to a standardized test method,
can be used to compare different tools with each other and
for a preliminary assessment of exposure. The measurement
values have been determined in accordance with
EN 60335-2-77:2010.
Value
40
4 Ah
Li-ion
2800–3200 rpm
IPX4
46 cm
55 L
25–80 mm
26 kg
76.3 dB(A), K=3 dB
87.7 dB(A), K=0.3 dB
88 dB(A)
0.51 m/s2, K=1.5 m/s2
43