Assembly; To Do Before You Assemble The Product; To Assemble The Product; Installation - Meec tools 024998 Bedienungsanleitung/Übersetzung Der Originalanleitung

circulation problems in the hands and arms, or Raynaud's
syndrome (white fingers). Stop working immediately and
seek medical attention if you experience numbness,
itching, tingling or pain, or if your skin changes colour.
Limit the risk of injuries as a result of vibrations by
maintaining the tool correctly, keeping your hands warm
and taking breaks.
● Even if the product is used in accordance with the
instructions it is impossible to rule out all risk factors.
3

Assembly

3.1 To do before you assemble the
product
Warning! Do not allow children to play with the
packaging material. Keep plastic bags, plastic film and small
parts out of the reach of children – risk of suffocation.
● Remove all parts from the packaging.
● Remove all packaging materials and any transport
protection.
● Check that no parts are missing.
● Inspect the product and accessories for damage.
● If possible save the packaging until the warranty has
expired.

3.2 To assemble the product

1
Unpack the product and all the accessories and
check that all the parts are included.
2
Fasten the bottom handle on the mower with the
plastic knob (E). Make sure the cables are not in the
way. (Figure 2)
3
Attach the top handle to the bottom handle with a
plastic knob, washer and a screw on each side
(B,C,D). (Figure 2)
4
Attach the cables on the handle with the cable clip
(A). (Figure 2)
5
Assemble the grass catcher bag (A). (Figure 3)
6
Mowing with the grass catcher: Lift up the ejector
flap with one hand and hook on the grass catcher (B).
(Figure 3)
7
Mowing with side ejector: Lift up the ejector flap and
attach the ejector guard. (Figure 4)
Note: When you use the side ejector; remove the grass
catcher, if fitted, and fit the mulching unit. "5.8 To mow with
the mulching unit" on page 42.
4

Installation

4.1

To install the battery

● Open the battery cover. Put one or two batteries in the
compartment. (Figure 5)
Note! The lawn mower can be run on only one battery. The
lawn mower detects when one of the batteries is discharged
and switches automatically to the other one.
5

Operation

5.1

Safety key

● The product can only be started when the safety key is
inserted. Remove the safety key from the product after
use. (Figure 6)

5.2 To start and stop the product

Warning! The blade continues to move for a short
while after the drive handle is released.
1
Press in and hold the safety button (A). (Figure 7)
2
Push and hold the bail bar (B). The motor starts.
(Figure 7)
Note: The motor stops directly as soon as the bail bar is
released.

5.3 To operate the product

1
Press the drive bar against the handle (A). (Figure 8)
2
Adjust the drive speed with the shifter (B). (Figure 8)

5.4 To adjust the handle height

● There are three settings for the height of the handle. Use
the one most applicable. (Figure 9)

5.5 To adjust the mowing height

Warning! Switch off the product and remove the
safety key before adjusting the mowing height.
41