HOMCOM 820-052 Bedienungsanleitung Seite 4

Gently bring the heater level with the wall.
Mark the two bottom holes position-see Fig.5, remove the heater ensuring that the bottom
fixing bracket is rotated up.
Drill and fit wall plug.
Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down again and
use the screw provided to permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired position.
Place the front glass panel over the front of the heater aligning the hooks at each side of the
glass panel with the slots at each side of the heater body-See Fig.4. Then slide down the glass
panel in place. Again two people will be required for this operation.
Insert and tighten the front glass panel screw-See Fig.6 to secure the front glass panel to the
heater.(Only for 820-052 and 820-0357)
4