Jung FUD 1253 EB Bedienungsanleitung Seite 12

GB
2. Depress the programming key for
about 4 seconds to switch over to the
programming mode. The LED flashes
for about 1 minute. During this time, a
channel can be programmed.
3. Send a radio telegram from the selec-
ted transmitter; see „Radio-control
transmitter" operating instructions:
Programming a channel
Depress the channel key for more than
1 second.
Programming a lightscape key
Depress the lightscape key for more
than 3 seconds.
Programming a detector
Remove the battery for about 2 minutes
from the detector. Put the battery back
in place and make a movement inside
the detection range of the detector
within the next 15 minutes.
Programming a presence detector
or a light sensor
Remove the battery(ies) for about 2
minutes from the transmitter. After
putting the battery(ies) back in place,
the device starts transmitting program-
ming telegrams for about 30 s.
Important:
It is not possible to program a combi-
nation consisting of presence-control
detector, light sensor and detector.
4. The universal dimmer confirms a
successful storage operation by a
permanently lit LED.
5. The programming mode ends auto-
matically after about 1 minute or can
be terminated by a short depression
of the programming key (load is switched
on). The universal dimmer is then again
in the normal operating mode.
Important
• When all 30 memories are occupied,
it is necessary to delete an already
stored transmitter before a new one
can be programmed.
• Programming of a radio channel (e.g.
hand-held transmitter 'Komfort') always
includes automatic storage of the
functions of the All-ON or All-OFF key.
Deleting a radio-control transmitter
A radio-control-transmitter in the
dimmer's memory is deleted when the
same transmitter is programmed again
into the memory (see „Programming of a
transmitter").
All channels and lightscape keys etc.
must be deleted one by one.
Successful deletion is signalled by the
LED flashing faster.
GB