Herunterladen Diese Seite drucken

Jung FUD 1253 EB Bedienungsanleitung Seite 11

Vorschau ausblenden Andere Handbücher für FUD 1253 EB:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB
Extension units
The universal dimmer
with an extension unit
operation)
Connect one or more extension units to
terminal 1 of the universal dimmer.
Do not connect installation push-
buttons (make or break contacts) or
mechanical extension units.
Power boost units
Depending on load conditions, up to 10
power boost units can be connected to
the universal dimmer.
Use Tronic power boost units (built-in or
DIN-rail types) only in combination with
Jung Tronic transformers (capacitive
loads).
Use low-voltage power boost units (built-
in or DIN-rail types) only in combination
with conventional transformers (inductive
loads).
can be operated
(dobble-rocker
Important:
The universal dimmer requires a basic
load
suited to the type of load of the
power boost units
Connect the power boost units as shown
in the figures below.
: universal dimmer
: power boost unit (built-in)
: power boost unit (DIN rail)
Programming of a radio-control
transmitter
During programming of a transmitter, the
sensitivity of a radio-control receiver is
reduced to a range of approx. 5 m. The
distance between the universal dimmer
and the transmitter to be programmed
should be between 0.5 m and 5 m.
Procedure
1. Switch off the lamp connected to the
universal dimmer by depressing the
programming key briefly.
GB
.

Werbung

loading