EINHELL TC-US 380 Originalbetriebsanleitung Seite 20

•
Safety information
3. Proper use
The belt and disk grinding/sander is designed for
grinding/sanding all types of timber commensura-
te with the machine's size.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
The machine is allowed to be operated only with
suitable grinding/sanding belts which comply with
the data specifi ed in this manual.
To use the equipment properly you must also
observe the safety information, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the equipment
have to be acquainted with these operating
instructions and must be informed about the
equipment's potential hazards.
It is also imperative to observe the accident pre-
vention regulations in force in your area.
The same applies for the general rules of health
and safety at work.
The manufacturer will not be liable for any chan-
ges made to the equipment nor for any damage
resulting from such changes.
Even when the equipment is used as prescribed
it is still impossible to eliminate certain residual
risk factors. The following hazards may arise in
connection with the machine's construction and
design:
•
Harmful emissions of wood dust when used
in closed rooms.
•
The rotating parts of the device cannot be
covered for functional reasons. Therefore you
must exercise care and hold the workpiece
firmly to prevent it slipping which could result
in your hands coming into contact with the
grinding/sanding belt.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
GB
4. Technical data
Voltage .....................................230-240V ~ 50Hz
Power .........................S1 300 W | S6 20% 380 W
Idling speed n
Grinding/sanding disk Ø ........................ 150 mm
Grinding/sanding disk grit size: ..................... K80
Tilting range of grinding/sanding table: .... 0°-60°
Cross stop ........................................ -60° to +60°
Grinding/sanding belt speed v
Grinding/sanding belt dimensions: 914 x 100 mm
Grinding/sanding belt grit size: ...................... K80
Dust extraction connector: ................... Ø 36 mm
Protection class: ................................................. I
Weight: .......................................... approx. 14 kg
Operating mode S6 20%: Continuous operation
with idling (cycle time 10 minutes). To ensure that
the motor does not become excessively hot, it
may only be operated for 20% of the cycle at the
specifi ed rating and must then be allowed to idle
for 80% of the cycle.
Danger!
Noise
The noise emission values were measured in ac-
cordance with EN 62841.
Operation
L
K
L
K
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
The stated noise emission values were measured
in accordance with a set of standardized criteria
and can be used to compare one power tool with
another.
The stated noise emission values can also be
used to make an initial assessment of exposure.
Warning:
The noise emission levels may vary from the level
specifi ed during actual use, depending on the
way in which the power tool is used, especially
the type of workpiece it is used for.
- 20 -
www.sidirika-nikolaidi.gr
....................................1500 min
0
sound pressure level ........................ 75 dB(A)
pA
uncertainty ........................................ 3 dB(A)
pA
sound power level .......................... 88 dB(A)
WA
uncertainty ........................................ 3 dB(A)
WA
-1
...........292 m/min
0