HANSGROHE Massaud 18112000 Gebrauchsanleitung, Montageanleitung Seite 4


Safety Notes
Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal

pressures.
Installation Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 0,15 MPa.
Technical Data
This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
This mixer is equipped with a flush stream, which
enhances the natural side of the life element water. As
this flush stream does not contain any air, we recommend
the use of Axor Massaud basins or very deep basins to
prevent water spray.
4
English
Symbol description
®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 33)
Flow diagram
(see page 33)

with EcoSmart
®

without EcoSmart
®
Spare parts (see page 34)
Operation (see page 35)
Cleaning
see enclosed brochure.
Test certificate (see page 35)