Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.2.14 Digital I/O Page
From menu entry Digital I/O it is possible to configure
the Digital Input and Output channels available in the
device.
• Digital Inputs: The status of the alarms can be
monitored thanks to the icon on the page. In
normal conditions, the icon will be green, while it
turns red if an alarm is detected.
• Digital Outputs: Using the Disable Relay/Enable
Relay buttons, you can force the output status.
Alternatively, the relay can be configured via VMS
(Video Management System), ONVIF S protocol (
11.1 Special controls, page 35).
The function DIgital Output is only valid if
the wash system is disabled.
• Disables the Relay/Enables the Relay
Fig. 45
Fig. 46
34
10.2.15 Device Statistics page
From menu entry Device Statistics all of the statistics
are gathered during device operation are provided in
read-only mode.
Fig. 47
10.2.16 Tools Page
From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of
device or only for a number of specific sections.
This section:
• Update the firmware of the device.
• Restart the device.
Fig. 48
MNTCMPXHDB_1824_EN
Werbung
