Radson Tempco CP W Bedienungsanleitung Seite 22

All manuals and user guides at all-guides.com
2.1.5 I.T.C.S function
The Intelligent Temperature Control System will activate your
installation in advance to assure the desired temperature at the
hour programmed following your weekly program.
This automatic control system works in the following way:
When you start your thermostat for the first time, it will measure the
time taken by your installation to reach the set temperature. The
thermostat will re-measure this time at each program change to
compensate external temperature change & influence. You can
now program your thermostat without the need to adjust the
temperature in advance because your thermostat does it
automatically for you.
Select the line with the arrow cursor and Press (Ok) to choose
"Yes" or "no".
Note:
- The maximum time of the ITCS anticipation will be 2 Hours.
- You can see the start up of this function on the status line in the
main screen. (Small logo ITCS will be blink)
2.1.6 Cooling Function
Use this function if you don't need cooling function on the room
managed by the programmer.
Example:
Cooling function should be deactivated for room with residual
humidity, like Bathroom, kitchen...
Zones Thermostat
Rename
Working Mode
Program
 ITCS
Cooling Function yes
Monday 27 / 04 / 2009
11 :15
22.6
33%
22
No
°C
ITCS