Werbung
USING VOICE RECOGNITION
To use voice recognition, the voice recognition feature must be enabled on
GB
your device. See your Bluetooth device manual for instructions. With the
Headset on, one long press on the Call Control Button will activate the voice
recognition feature on the Headset.
MUL TIPLE USES OF A LONG PRESS ON THE CALL
CONTROL BUTTON
BLUETOOTH
HEADSET FUNCTION
DEVICE STATUS
Turn on power
Re-link to
Bluetooth device
Link dropped
Reject call
Incoming call
Transfer a call between
Headset and Bluetooth device
Voice recognition
HEADSET STATUS
Powering on
Power on
Powering off
Power off
Charging battery
Battery fully charged
Discovery mode
Missed call
Ringing
On Line Indicator (OLI)
Low battery
36
69328_061405.indd 36-37
RESULT
Power off
Turns the power on
Power on
Re-links the device
Power on
Disconnects the call or sends the call to
Linked
voice mail, depending on your device
Power on
Transfers the call from
Linked
one device to another
On a call
Power on
Linked
Activates the voice recognition feature
No call
HEADSET STATUS INDICATOR
Blue light appears and flashes every 6 seconds
Blue light flashes every 6 seconds
Red light appears and goes off
Indicator is not lit
Red light is on
Red light is off
Indicator flashes blue and red for 30 seconds
Infrequent flashing blue/red
Press any button to cancel
Rapid flashing blue/red
Blue flash every 10 seconds
Flashes red
TROUBLESHOOTING
MY HEADSET DOES NOT WORK WITH MY PHONE.
POSSIBLE CAUSE
Headset was not in discovery mode when
mobile phone menu selections were made
Incorrect menu selections were
made on your mobile phone.
I DID NOT ENTER MY PASS KEY.
POSSIBLE CAUSE
Your phone did not locate the Headset.
Incorrect menu selections were
made on your mobile phone.
CALLERS CANNOT HEAR ME.
POSSIBLE CAUSE
Mute is turned on.
I CANNOT HEAR CALLER/DIALLING TONE.
POSSIBLE CAUSE
The Headset is not turned on.
Your Headset is out of range.
Your Headset battery is flat.
The listening volume is too low.
SOLUTION
See page 19 "Bluetooth Pairing" .
See page 19 "Bluetooth Pairing" .
SOLUTION
Repeat the Pairing process on page 19.
Repeat the Pairing process on page 19.
SOLUTION
Press both sides of the
Volume/Mute Button simultaneously.
SOLUTION
Press the Call Control Button for 2 seconds until you hear
a beep or see the Headset Status Indicator glow blue.
Press the Call Control Button for 2 seconds until you hear
a beep or see the Headset Status Indicator glow blue.
Charge your battery using the AC Power Adapter
supplied, the AC Adapter from your mobile phone,
or a AAA battery.
Press the top part of the Volume/Mute Button
to increase the sound heard in the Headset.
6/15/05 6:51:02 PM
37
Werbung
