BaByliss E842XE Bedienungsanleitung Seite 8

ENGLISH
E842XE BEARD
MOUSTACHE TRIMMER
1. 1 cutting guide for 30
lengths (from 0.5mm to
15mm, in 0.5mm increments)
2. 2 cutting
different widths: 32mm to
trim your beard and 7mm to
style it
Moveable blade:
- Exclusive three-dimensional
etching process:
exceptionally sharp cutting
edge.
- CMS (Chrome-Molybdenum-
Stainless
hardwearing
stainless steel blade.
Fixed Blade:
- TITANIUM
increased longevity
These 2 technologies provide
a perfect surface condition
and combining them is ideal
for reducing
coefficient.
3. 1 special '3-day beard'
cutting guide
4. ON/OFF button (2 speeds)
5. Wheel to adjust the cutting
length
6. Charging indicator light
7. plug for use on the mains
and for charging
8. Cleaning brush
AND
blades with
for
Steel): ultra-
and 100%
coating:
for
the friction
IMpORTANT
REGARDING
BATTERIES OF THIS UNIT
To obtain and maintain the
longest battery autonomy
possible, allow it to charge
for 16 hours before using it
for the first time and then
approximately every three
months. Full autonomy of
the unit will only be obtained
after three complete recharge
cycles.
CHARGING THE TRIMMER
an
1. Plug the cord into the unit
and connect the transformer.
Before using the trimmer
for the first time, allow it to
charge for 16 hours. Make
sure the trimmer's switch is in
the OFF position.
2. Check that the charging
indicator light is lit.
3. A full charge provides a
minimum of 30 minutes' use
of the trimmer.
USE ON THE MAINS
To use the trimmer on the
mains, plug the chord directly
into the unit.
Plug the trimmer, in the OFF
position, into the mains and
switch ON (If the battery is very
weak, wait about 1 minute).
IMPORTANT! Use only the
transformer provided with the
trimmer Ref. E842XE Voltage =
3V – 600mA.
HANDLING THE COMB GUIDE
The comb guide is very practical
8
INFORMATION
THE NI-MH