Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Attach the ceiling unit (lower section).
Ceiling unit
(upper section)
Washer pan nut
M8 assembly screw
(Example)
Ceiling unit
(lower section)
5. Prepare the display.
Install the insulating spacers in the display unit.
Lay the display with the screen facing down on a clean blanket or sheet and follow the steps
below.
Remove the four bolts.
Spring washer
Fixing bolt（M8-100）
M8 assembly screw
M8 bolt
（M8-12）
Hidden
White line
side
①
②
③
1. Match the height adjustment holes on
the upper and lower sections to the
desired height and refasten in place
with two M8 assembly screws.
2. Insert the fixing bolt (M8-100) through
the spring washer and then insert it
through the uppermost hole in the pipe.
Fasten in place with the washer pan
nut (all included).
3. Tighten with two fixing bolts (M8-12,
included) so that the lower section
does not move.
Note
• When adjusting the height, no more that 4 holes should
be visible. (The white line should not show.)
Height adjustment
holes
Center of
display
1. Remove the four bolts from the display.
2. In each of the four bolt holes, insert a
pan head bolt with hex socket (M8-45),
toothed pan washer and insulating
spacer (four each, all included). Insert
as shown in the diagram on the left.
①
Pan head bolt with hex socket
②
Toothed pan washer
③
Insulating spacer
Distance from
center of display
to ceiling ( in.)
1085mm (42
)
23/32
985mm (38
25/32
)
885mm (34
27/32
)
785mm (30
)
29/32
5
Werbung
