Swim & Fun 1085 Bedienungsanleitung Seite 78

10.2 Wiring diagram
The electrical wiring diagram is
only for general reference.
The swimming pool heat pump
must be connected to the ground
wire, although heat exchanger
unit is electrically isolated from
the rest of the unit. The unit must
still be earthed in order to protect
against short circuits inside the
unit. Bonding is also required.
A power switch should be lo-
cated within sight and be easily
accessible from the heat pump.
This is common practice on
commercial and residential heat
pumps. It allows you to turn off
the power to the unit while it is in
operation.
10.3 Exploded view
No. Part name
1 Top cover
2 Evaporator
3 Pillar
4 Electric box cover
5 5-position terminal
6 Motherboard
7 Clip
8 Clip
9 Fan motor capacitor
10 Compressor capacitor
11 Electric box
12 Fan motor bracket
13 Fan motor
14 Fan blade
15 Front panel
16 Front grill
17 Isolation panel
18 Service panel
19 Compressor
ater flo s it
20
21 Bottom tray
22 Heat exchanger
78
No. Part name
23 Right panel
24 Temp. knob
25 Electric plug
26 Electric plug
27 Meter
28 Blue rubber ring
29 Water connection cover
30 Switch
31 Red rubber ring
32 Water connection cover
33 Anti-vibration hammer
34 High pressure protection sensor
35 Return gas pipe
36 Exhaust pipe
37 Suction valve
38 Low pressure sensor
39 Pipe
40 Pipe
41 Distributor pipe
42 Ambient temp. sensor clip
43 Ambient temp. sensor
MV-1085-1086-1093-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK