Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. dditional c ecks ust e perfor ed
• The function of all safety components must be checked.
• Check that all metal elements are correctly earthed.
• The power connection and fitting of the electric power cable must be checked
Important:
Incorrect installation can cause overheating and will void the warranty.
3. Starting and Stopping the heat pump
Turn on the filter pump, check for water leaks and check the water flow of the swimming pool.
As shown in the picture below: when the switch is in the "OFF" position, turn it to the "ON" position
to start the heat pump.
Turn it back to the "OFF" position to stop the heat pump.
4. Set the water temperature
As shown in the picture below, you can set the desired water temperature in intervals from 0°c to
40°c, by turning the temperature adjustment knob.
• Turn clockwise = Decrease the temperature setting
• Turn anticlockwise = Increase the temperature setting
74
a ualified tec nician:
MV-1085-1086-1093-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK
Werbung
