SICK FGS 300 Bedienungsanleitung Seite 143

Operating Instructions
FGS
8 007 716/KA 06/31-03-00
Technical Data
1
) The voltage must not exceed or fall below the limit values.
2
) Applies for voltages between U
3 ) In the case of an error (interruption of the 0 V cable) the outputs
behaves like a resistor > 13 k
element must identify this state as LOW.
4
) With a low switching frequency
inductance L is higher.
L (H)
20
1
10
2
0
0 1.0 2.0 3.0
55
) In the active state, the outputs are tested in a cycle (switch LOW
briefly). When selecting the downstream control elements ensure
that the test impulses with the parameters listed above do
not lead to a shutdown.
6
) The individual conductor resistor to the downstream control
element must be limited to this value so that a crossed connection
between the outputs can be identified. (EN 60 204 Electrical Equip.
of Machines, Part 1: General Requirements must be observed.)
7
) This value applies if the synchronization beam is interrupted
(1st beam below the LED display).
8
) With screening, recommended with chamber EMC
(Order no. 2 019 586 (FGSS), 2 019 585 (FGSE)
© SICK AG • Safety Systems • Germany • All rights reserved
and 0 V.
V
after U . The downstream control
V
1
/s the max. permissible load
I 400 mA
1
L
I 500 mA
2
L
1/s
4.0
GB
Chapter 10
143