Klarstein HARRISON Bedienungsanleitung Seite 44

EN
44
ADDITIONAL SETTINGS
Internal parameter setting
In the switched-off state, press and hold the UP or DOWN button for 10 seconds
to enter the internal parameter settings. Press the MENU button to access the
following settings: Temperature compensation > exit settings.
Factory reset
If the device is turned on and the POWER button is pressed and held for 10
seconds, the system will automatically reboot and restore the factory settings. The
display will show the full screen for 3 seconds and then turn off. Then press the
POWER button again.
In the factory setting, the normal mode temperature is 50 °C and the drying time
is 2 hours. The time is displayed as 12:00. The day of the week is set to 1, the week
program returns to the default value and the temperature compensation is -2 °C.
Temperature compensation setting
Temperature compensation is set to -2 °C by default.
The temperature compensation can be set by briefly
pressing the UP or DOWN buttons. The temperature
compensation range can be set in increments of 1 °C
between 5 °C and -5 °C.