Installing Diagnostic Software - Stihl ADG 2 Gebrauchsanleitung

English
Recommended configuration
CPU 2 GHz
–
512 MB free memory
–
a minimum of 100 MB hard disk
–
space
Resolution – SVGA monitor
–
(minimum resolution 1024 x 768)
USB interface 1.1 or higher
–
CD-ROM or DVD drive
–
24
Installing Diagnostic
Software
Sequence
It is essential to observe the sequence of
the steps described. Only then will the
STIHL diagnostic software be properly
installed on the computer and the
analyzer connected to the computer.
1 Check system requirements – see
"Diagnostic Software".
2 Place CD-ROM in the compueter's
CD-ROM or DVD drive and start the
setup program – see "Installation of
STIHL Diagnostic Software".
3 Connect analyzer to power supply –
see "Connecting Analyzer to Power
Supply".
4 Plug in and connect the USB cable
– see "Connecting Analyzer to
Computer".
5 Start STIHL diagnostic software –
see "Connecting Analyzer to
Computer".
Installation of STIHL Diagnostic
Software
Place the CD-ROM in the computer's
CD-ROM or DVD drive.
Automatic start
The automatic start functions only if the
computer supports automatic starting of
a program from a CD-ROM
(AUTORUN). If the setup program on
the computer does not start
automatically, start it manually.
Manual start
Open "My Computer" and select
computer's CD-ROM or DVD-ROM
drive. Launch installation with double-
click on "SDSSetup.exe".
Installation via Internet
The diagnostic software is also available
from
https://download.stihl.com/sds/sdssetup
.exe
Login data
User name: _stihl_sds_user
Password: STIHL_diagnose_download!
ADG 2