Light Emitting Diodes (Leds) On Analyzer; Diagnostic Software - Stihl ADG 2 Gebrauchsanleitung

If the red light emitting diodes glow /
flash
1 light emitting diode Battery too
glows continuously hot/cold
red:
4 light emitting diodes Fault in battery
flash red:
1)
Remove the battery from the
analyzer to cool it down/warm it up.
After cooling down/warming up,
restart the test – insert the battery
in the analyzer.
2)
Take the battery out of the analyzer
and refit it again – if the LEDs still
flash, the analyzer is faulty and
must be replaced.
ADG 2
Light Emitting Diodes (LEDs)
on Analyzer
The light emitting diode (1) on the
analyzer can glow or flash green, yellow
or red.
1)
Green continuous light
2)
Cordless power tool or function in
–
order.
Yellow continuous light
Intermittent fault in cordless power
–
tool in the past (e.g. loose contact),
power tool ready for operation at the
moment – the fault can be called up
in the power tool's fault memory.
Red continuous light
Active fault in cordless power tool,
–
power tool is not ready for operation
at the moment – a fault code is
displayed.
Problem – see "Troubleshooting"
–
Red flashing light
... may mean the following:
Observe safety information on
–
display
Fault in analyzer (analyzer's display
–
remains blank) – software update
required.

Diagnostic software

STIHL diagnostic software may be used
only in conjunction with STIHL
analyzers.
System Requirements
1
STIHL diagnostic software may only be
installed on a computer that meets the
system requirements. Administrator
rights are required for installation under
®
Microsoft Windows
system administrator if necessary.
Operating System
®
Microsoft Windows
–
®
Microsoft Windows Vista
–
®
Microsoft Windows
–
Software Requirements
®
Microsoft .NET 3.5 SP 1 or higher
–
®
Adobe Acrobat
–
higher
Hardware Requirements
Minimum Requirements
CPU 1 GHz
–
256 MB free memory
–
a minimum of 100 MB hard disk
–
space
Resolution – SVGA monitor
–
(minimum resolution 1024 x 768)
USB interface 1.1 or higher
–
CD-ROM or DVD drive
–
English
®
– contact the
®
XP SP 3 or
®
or
®
7
®
Reader 9 or
23