Atlas Copco 8426111104 Sicherheitshinweise Seite 4

Safety Information
legislation and based on legit exemptions in the RoHS Direc-
tive (2011/65/EU). Lead metal will not leak or mutate from
the product during normal use and the concentration of lead
metal in the complete product is well below the applicable
threshold limit. Please consider local requirements on the dis-
posal of lead at product end of life.
Regional Requirements
WARNING
This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more
information go to
https://www.p65warnings.ca.gov/
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
power tool.
Failure to follow all instructions listed below may result
in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Intended Use
This product is designed for chipping, riveting, scaling, or
ramming, according to its operating instructions. No other use
permitted.
Product Specific Instructions
General
If different RRH 04/06/08P models are in use at the same
workplace all 1.7 mm wire retainers (black) shall be
withdrawn and replaced by 2.0 mm wire retainers (yel-
low) on all hammers. This is due of safety reasons, i.e. to
prevent mixing up the retainers and using the wrong type
on the wrong hammer model.
4 © Atlas Copco Industrial Technique AB - 9836 5492 00
Installation
Installation of Vibrating Tools
We recommend using a minimum length of 300 mm (12") of
flexible hose for compressed air between a vibrating tool and
the quick coupling.
Setting Up
Setting-up instructions
Check the tool before starting work
• Always use a retainer.
• Inspect the retainer for wear and damage regularly.
• The tool and its accessories must not be modified in any
way.
• The trigger must never be removed or fixed by tape for
example.
• If the trigger is not working properly, make sure that it is
replaced.
• The air supply coupling should be separated from the tool
by a whip hose.
Personal protection equipment
Make sure to wear:
• Eye protection, goggles or a visor.
• Ear protection.
• Gloves.
• Steel toe-capped shoes.
• A helmet (for heavier applications).
• Avoid loosely hanging clothing, hair, jewellery (risk of
getting caught).
Operation
Operation instructions
Working area
• Ensure that the area in which you are working is kept free
from other people so that no one can get injured.
• People nearby must also wear hearing and eye protection.
• Check that there is good ventilation and dust extraction
from the premises.
• There should be a stand or a place available, on which the
machine can be safely placed.
• Work within a sealed-off area, if possible with protecting
walls.
• Explosive atmosphere must not be ignited - use acces-
sories of non-sparking material.
• Avoid chiselling into electric wiring hidden inside walls.
During work
• Before changing accessories, chisel or die, disconnect the
tool from the air supply,
• Stop using the tool if abnormally loud noises and vibra-
tions occur during use.
• Be aware that the chisel may break during operation.
RRH06P