Instrument Panel - Ransomes Parkway 2250 plus LGNN040 Betriebshandbuch

6.13 INSTRUMENT PANEL

A. ENGINE PREHEAT INDICATOR LAMP
Colour green, on when the ignition switch is turned
clockwise to the pre-heat position. Once the lamp
goes out the engine can be started.
B. ENGINE TEMPARATURE GUAGE
Indicates current temparature of engine, whilst
running.
C. ENGINE OVERHEAT WARNING LAMP
Colour red, on when the engine temperature reaches a
preset level. If the lamp comes on and a warning horn
is sounded bring to machine to a stop, disengage the
cutting cylinders, apply the parking brake and allow
the engine to cool by running the engine at half speed
for two minutes before stopping and investigating the
cause.
D. CHARGING WARNING LAMP
Colour red, on when ignition is switched on and will go out
when the engine is started. If the light comes on while
the engine is running, the fan belt may be slipping or
broken or a fault in the electrical system is indicated and
should be investigated. STOP IMMEDIATELY.
E. ENGINE OIL PRESSURE WARNING LAMP
Colour red, on when the ignition is switched on, and will
go out once the engine has started. If the light comes on
while the engine is running - STOP IMMEDIATELY as
this indicates that the engine oil pressure is too low.
Check the level of oil in the sump and top up as
necessary. Check the oil pressure sender switch.
Continued operation may cause extensive damage to the
engine.
F. ROTATING BEACON
Press the bottom half of the switch to activate the
flashing beacon. (Where fitted)
G. HEAD LIGHT/SIDE LIGHT
Depress the bottom half of the switch to turn on the
headlights and sidelights. (Where fitted)
H. DIRECTIONAL INDICATORS
Depress left hand-side of switch to signal left, and
right hand-side of switch to signal right. (Where
fitted)
I. HAZARD WARNING LIGHTS.
Press the top half of the switch to turn on the hazard
warning lights. (Where fitted)
GB-16
RANSOMES PARKWAY 2250 PLUS
SAFETY AND OPERATORS MANUAL