Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Danger!
The equipment and packaging material are not toys. Do
not let children play with plastic bags, foils or small
parts. There is a danger of swallowing or suffocating!
3. PROPER USE
This power tool is intended to function as a sander and
polisher.
4. Technical Data
Charger
Battery capacity
Battery voltage
Charging time
No load speed
Spindle thread size
Backing pad diameter
Weight
Danger!
Sound and vibration
Sound and vibration values were measured in accordance with
EN 62841.
L
sound pressure level
pA
K
uncertainty
pA
L
sound power level
WA
K
uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing. Total
vibration values (vector sum of three directions) determined in
accordance with EN 62841.
Vibration emission value a =1.358 m/s² K uncertainty = 1.5
m/s²
Warning!
The specified vibration value was established in accordance
with a standardized testing method. It may change according
to how the electric equipment is used and may exceed the
specified value in exceptional circumstances.
The specified vibration value can be used to compare the
equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Input:100-240V~,
50/60Hz 0.8A,
Output:13.5VDC,2.0A
2000mAh/pack
Maximum 12V/Nominal 10.8V
Approx. 1 hour
L: 0-2800/min
H: 0-7500/min
M8
3" (75mm)
0.88kg(1.94lb)
69.6 dB(A)
3 dB
80.6 dB(A)
3 dB
GB
Warning!
The vibration emission during actual use of the power tool
can differ from the declared total value depending on the
ways in which the tool is used.
It's necessary to identify safety measures to protect the
operator that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched
off and when it is running idle in addition to the trigger
time).
Keep the noise emissions and vibrations to a minimum.
Only use appliances which are in perfect working order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in accordance with
instructions, certain residual risks cannot be rules out. The
following hazards may arise in connection with the
equipment's construction and layout:
Lung damage if no suitable protective dust mask is used.
Damage to hearing if no suitable ear protection is used.
Health damage caused by hand-arm vibrations if the
equipment is used over a prolonged period or is not properly
guided and maintained.
5. ASSEMBLY
WARNING: Do not use this product if it is not completely
assembled or if any parts appear to be missing or damaged.
Use of a product that is not properly and completely
assembled or with damaged or missing parts could result in
serious personal injury.
5.1 Inserting/Removing the Battery (Fig. 2)
To remove the battery, push in the release buttons and pull
the battery pack away from the tool.
To insert the battery, slide the pack into the body of the tool.
Make sure it latches securely into place.
5.2 Inserting/Removing the side handle (Fig. 3)
The side handle may be installed on either side or top of the
gear case. Position the side handle in the location which
offers best control and guard protection. To install, thread
side handle into side handle socket and tighten securely.
To remove, thread side handle out from side handle socket
from the tool.
8
Werbung
