WorkPro W125108A Bedienungsanleitung Seite 11

3. Removing wax
Use a sponge pad. Run the tool to remove wax.
4. Polishing
Apply a sponge pad gently to the work surface.
6.6 Sanding operation (Fig. 11)
CAUTION: Never switch on the tool when it is in
contact with the workpiece, it may cause an injury to
operator.
CAUTION: Always wear safety goggles or a face
shield during operation.
CAUTION: After operation, always switch off the tool
and wait until the backing pad has come to a complete
stop before putting the tool down.
ALWAYS hold the tool firmly with one hand on rearhandle and
the other on the side handle. Turn the tool on and then apply
the sandpaper to the workpiece.
In general, keep the abrasive disc at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to abrasive disc.
7. CLEANING, MAINTENANCE
Danger!
Always remove the battery pack before making
adjustments to the equipment.
7.1 Cleaning
Keep all safety devices, air vents and the motor housing free

of dirt and dust as far as possible. Wipe the equipment with
a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each

time you have finished using it.
Clean the equipment regularly with a moist cloth and some

soft soap. Do not use cleaning agents or solvents; these
could attack the plastic parts of the equipment. Ensure that
no water can seep into the device. The ingress of water into
an electric tool increases the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which require
additional maintenance.
GB
8. STORAGE
Store the equipment and accessories in a dark and dry place
at above freezing temperature. The ideal storage temperature
is between 5°C(41°F )and 30°C(86°F). Store the electric tool in
its original packaging.
For storage, it is suggested to recharge the battery between
50% and 75% charge.Charge the device at least once in 3-6
months to preserve battery life span.
9. DISPOSAL AND RECYCLING
The equipment is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this packaging
can be reused or recycled. The equipment and its accessories
are made of various types of material, such as metal and
plastic. Never place defective equipment in your household
refuse. The equipment should be taken to a suitable collection
center for proper disposal. If you do not know the
whereabouts of such a collection point, you should ask in your
local council offces.
Environmental protection
This product has been marked with a symbol
relating to removing electric and electronic waste.
This means that this product shall not be discarded
with household waste but that it shall be returned to
a collection system. It will then be recycled or
dismantled in order to reduce the impact on the
environment. Electric and electronic equipment can
be hazardous for the environment and for human
health since they contain hazardous substances.
Disposal of an exhausted battery
pack
To preserve natural resources, please recycle or
Li-ion
dispose of the battery pack properly. This battery
pack contains Li-ion batteries. Consult your local
waste authority for information regarding available
recycling and/or disposal options. Discharge your
battery pack by operating your tool, then remove the
battery pack from the tool housing and cover the
battery pack connections with heavy-duty adhesive
tape to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the
components.
10