Therabody TheraFace PRO Bedienungsanleitung Seite 8

C. Microcurrent Treatment
1.
Remove any percussive therapy attachment before attaching the
Microcurrent Ring.
2. Prior to starting the microcurrent treatment, apply the TheraOne™
Conductive Gel to your clean, dry face or treatment area to ensure
the treatment is delivered correctly.
3.
Attach the Microcurrent Ring to the TheraFace P RO device.
4. Once attached to the TheraFace PRO, turn ON the TheraFace PRO
device by pressing the Power Button for 2 seconds.
5.
Turn on the microcurrenttreatmentby pressing the ring button once.
6.
Toadjust the intensity level to your comfort, press the ring button once
to toggle between the 3 intensity options.
7. Tostop the microcurrenttreatment, press the ring button a third time.
PRO Tip:When using the Microcurrent Ring, slowly glide the device using light
to medium pressure, keeping both spheres on the face at once. A microcurrent
protocol of 5-8 minutes can be completed once per 24-hour period. Be sure to
visit therabody.com for treatment protocols and instructional videos.
Note: •There is a preset shut off time of 8 minutes
Cannot be combined with the percussive therapy attachments
•
While the Microcurrent Ring will work with any conductive gel, we
•
recommend the TheraOne™ Conductive Gel if available in your market.
Warning: When using the TheraFace PRO with the Microcurrent Ring, a
microcurrent primer is required. Do NOT use theMicrocurrent Ring on themidline
of theneck or eye area.
D. Microcurrent Primer: TheraOne Conductive Gel
The TheraOne™ Conductive Gel is a primer intended to be used with the
TheraFace PRO device prior to startingthe microcurrent treatment to ensure
the treatment is delivered safely and effectively.
Directions:
1.
Start with a clean, dry face.
2.
Apply a mask-like layer of the conductive gel to all treatment areas
of the face and neck.
3.
Following treatment with the microcurrent ring, rinse off and apply
your favorite moisturizer.
E N
8