Therabody TheraFace PRO Bedienungsanleitung Seite 7

Using the TheraFace PRO
E N
Start by washingyour face completely and rinse twice to remove residue.
Allow skin to dry completely before starting treatment. Be sure to visit
therabody.comfor treatment protocols and instructional videos.
Note: The TheraFace PRO device
will make a beeping sound every 15
seconds. This will help you track the
time within each treatment and will
also inform you if a treatment has
been disconnected or is completed.
A. Percussive Therapy Feature
1. Select and attach the desired percussive therapy attachment
2. Once attached to the TheraFace PRO, turn O N the TheraFace P RO
device by pressing the Power Button for 2 seconds.
3. Turn on the percussive feature by pressing the percussive button once.
To toggle between the 3 speed options (1750, 2100 and 2400 rpm), press
4.
the percussive button again.
To stop the percussive treatment, press the percussive button a third time.
5.
Note: •Can be combined with Hot and Cold Rings* - (*Hotand Cold Rings sold separately)
Cannot be combined with the Microcurrent attachment or with the LED ring
•
7
• 1beep =timed feedback every 15sec so you
can time their protocolsbetter
• 2 beeps =the LED, Microcurrent,Hot, or Cold
treatment has been accidentally disconnected
• 3 beeps =the LED, Microcurrent,Hot, or Cold
treatment is over
B. LED Treatment
1.
The LED ring has 3 light therapy wavelength options: red, blue and
red+infrared.
2. To start using the LED therapy mode, attach the LED ring to the
TheraFace P RO device.
3.
Turn O N the TheraFace P RO device by pressing the Power Button
for 2 seconds.
4. Then, turn O N the LED ring by pressing the Attachment Ring button.
5.
To toggle between light options (blue, red and red+infrared), press
the Attachment Ring button again.
6. The TheraFace P RO LED ring has a proximity sensor system, and will
only reach full light intensity (brightness) once the device is placed at
the right distance from your face (0.5 inches), reducing glare in the
interim. Avoid direct skin contact.
7. To turn off the LED ring, toggle to the Red+IR light mode and
press the Attachment Ring Button one more time or power off the
TheraFace P RO device by pressing the Power Button for 2 seconds.
Warning: Do not place theLED Ring directly on theskin. Keep theLED
Ring approximately 0.5 inches away from theskin.