Installing "Sensme™ Setup" And "Content Transfer" In Your Computer; Transferring Tracks To The Usb Device Using "Content Transfer - Sony CDX-GT650UI Bedienungsanleitung

Tip
Registration can be performed either along with the
installation procedure or after installation.
3 Transferring tracks to the USB device
using "Content Transfer"
In order to group tracks by channel, track
sound patterns need to be analyzed by 12
TONE ANALYSIS™, which is loaded in
"Content Transfer."
With the USB device connected to your
computer, drag and drop tracks from Windows
Explorer or iTunes, etc., to "Content
Transfer."
Both analysis and transfer of tracks will be
performed by "Content Transfer."
Content
Transfer
4 Connecting the USB device and
enjoying the SensMe™ function on the
unit
Connect the set up USB device. You can then
enjoy "SensMe™ channels" on this unit.
Installing "SensMe™ Setup" and
"Content Transfer" in your
computer
Use of the supplied software ("SensMe™ Setup"
and "Content Transfer") is required to enable the
SensMe™ function on this unit.
Install the software in your computer from the
supplied CD-ROM.
1
Insert the supplied CD-ROM into your
computer.
The Installation Wizard runs automatically.
2
Follow the on-screen instructions to
complete the installation.
Registering a USB device using
"SensMe™ Setup"
USB device registration is required to enable the
SensMe™ function on the unit.
If registration is not performed along with the
installation procedure, follow the steps below.
1
Start "SensMe™ Setup" on your
computer.
2
Connect a USB device to your
computer.
3
Complete registration following the
on-screen instructions.
Tip
If you connect a registered USB device containing
analyzed tracks, the USB device can be unregistered
again.
Transferring tracks to the USB
device using "Content Transfer"
To enable the SensMe™ function on this unit,
tracks need to be analyzed and transferred to the
registered USB device, using "Content Transfer."
1
Connect the registered USB device to
your computer.
For USB devices, connect with the MSC
mode.
"Content Transfer" starts automatically.
If a message appears, follow the on-screen
instructions to proceed.
2
Drag and drop tracks from Windows
Explorer or iTunes, etc., to "Content
Transfer."
The analysis and transfer of tracks start.
For details on operations, see the Help of
"Content Transfer."
Note
The track analysis by 12 TONE ANALYSIS™ may take
time, depending on the computer environment.
15