HumanTechnik signolux S Bedienungsanleitung Seite 15

Deleting transmitters
Do the following if you want to delete a
transmitter from the memory:
a) Keep the function button »●« (fig. 2)
pressed for some time. The icons light
in se
up quence. Let go of the key as
soon as you see the desired event icon.
b) Now press the function button »●« and
the melody setting button »♫« (fig. 2),
at the same time, until all icons briefly
light up.
Please note that this will remove all as-
signed transmitters from the selected event
icon.
Battery level indication
The receiver informs about the state of the
batteries of the receiver as well as the bat-
teries of the transmitters:
- A sufficient battery level of the receiver
is indicated by the red control lamp
flashing every 5 to 6 seconds.
- A low battery level of the receiver is in-
dicated by the red control lamp flashing in
short sequence (once per second).
Please recharge the receiver batteries as
soon as possible.
- A low battery level of a transmitter is
indicated by the red control lamp
shining together with the event icon of the
according transmitter when it's signal is
triggered.
Please replace the batteries of the ac-
cording transmitter as soon as possible.
Further functions
Recalling the last alert, cancelling the
current alert
By pressing the »●« button (fig. 2) the last
registered alert can be displayed again.
You can also cancel an active displayed
alert by pressing this button.
Figure 4: Lateral connectors
AUX-socket and power connector
The »AUX«-jack and the connector for the
power adapter can be found on the right
side of the receiver.
All Humantechnik modules can be connec-
ted to the AUX-output (vibrating pillow etc,
available as accessories)
AUX-output
Connector for
power supply
7,5 V
English 15