CleanSpace 2 Bedienungsanleitung Seite 5

English
3. Operating Instructions
POWER BUTTON
™
The CleanSpace2 Respirator has three (3) operating Modes: "On", "Standby" and "Off"
Mode.
i) Standby Mode is when the green battery indicator lights are on, the motor is not running
and there is no airflow to the mask. The Respirator will automatically switch to "Standby
Mode" within ten (10) seconds of the user taking off the Respirator. If the CleanSpace2
Respirator is in "Off Mode" it will switch to "Standby Mode" when the Power button is pressed.
ii) On Mode is when the Respirator is being worn, the motor is running and there is air flow to
the mask. The motor will start (called On Mode) when the Respirator detects a change in
pressure in the mask triggered by your breathing. In On Mode you should hear the motor
running and feel the airflow on your face.
iii) Off Mode is when the green battery indicator lights are off and the motor is not running
and there is no air flow to the mask. The Respirator automatically switches into Off Mode
three (3) minutes after the Respirator has been removed from the user's face and the sensors
detect that there is no "breathing".
To conserve battery life, the CleanSpace2
from On Mode to Standby then to Off Mode when not being worn. Important: The
™
CleanSpace2 switches into "On Mode" when the Respirator is in "Standby Mode" and the
wearer starts to breathe. The Respirator can only switch into "On Mode" from "Standby
Mode".
BATTERY INDICATOR LIGHTS
™
The CleanSpace2 Respirator is equipped with an indicator of battery charge. There are
three (3) battery indicator lights. If all three (3) lights are lit up the Respirator is fully charged
and typically has six (6) hours of operating time. The Respirator should be fully charged
before use. The CleanSpace2
lights illuminated. If two (2) battery indicator lights are on, the Respirator has between 25%
and 75% charge and will typically operate for between 2 and 4 hours. If only one (1) battery
indicator light is on, the battery has less than 20% charge and we recommend that you
charge the Respirator before use.
FILTER WARNING ALARM
™
All CleanSpace2 Respirators have a Filter Warning Alarm, which is triggered when the
particulate or combination filter is blocked. If the Filter Warning Alarm sounds (2 beeps every
second) and the Filter Warning Alarm light flashes, you should move out of the contaminated
area, remove the Respirator and change the filter (See the section in this user manual for
instructions on how to change the CleanSpace2
™
Respirator is designed to automatically switch
™
will function with one (1), two (2) or three (3) green battery
™
filters)
4
™