CleanSpace 2 Bedienungsanleitung Seite 11

English
6. CleanSpace2
For added safety, all CleanSpace2
ensure the batteries are protected against over-charge and over-discharge. The following precautions must
be followed during use:

Avoid mechanical shocks or impacts from any sharp or hard objects
 Do not use or place the Respirator in extreme heat, such as in direct sunlight, near heat sources, etc.
The battery will be damaged if its temperature goes above +70°C. Note: The CleanSpace2™ will stop
functioning if its internal temperature rises above +60°C or below -10°C

Do not dispose of the Respirator in fire

Do not use the CleanSpace2™ Respirator in heavy rain, or allow it to get wet or immersed in liquid
 Do not disassemble the Power Unit case, there are no user serviceable parts inside
 Do not use the CleanSpace2™ Respirator if there are any signs of severe mechanical damage
FLUSH WITH WATER IMMEDIATELY AND SEEK URGENT MEDICAL ATTENTION
7. Cleaning CleanSpace2
We recommend that you clean your Respirator after every use. The mask, Power Unit, neck pad and harness need
to be cleaned separately. Disassemble the mask, neck pad and harness from the Power Unit before cleaning.
Compatible cleaning wipes are recommended as a simple and effective method of cleaning the CleanSpace2
Power Unit and masks. For more information on compatible cleaning products contact CleanSpace at
sales@cleanspacetechnology.com
WASHING THE MASK
There are three (3) methods for cleaning the CleanSpace
covering the exhalation valve leaf. To remove the valve cap, find the small inlet located under the lower, inside edge
of the valve (see diagram). Use your fingernail to unclip and push up the valve cap. The valve cap is easily fitted
back by placing the cap with the clip aligned to the inlet on the valve seating and pushing down. The valve cap will
gently snap back into place.
1. Compatible wipes for face piece

To clean the exhalation valve, remove the valve cap (using the instructions above), gently wipe the leaf
edge. Replace the valve cap before use.
2. Hand wash in warm soapy water
 Wash the mask thoroughly with a mild detergent in warm water (<50°C)

A soft brush or sponge can be used to remove any stubborn dirt or grit
™
Battery Information (continued)
™
internal batteries have a built-in Protection Circuit Module (PCM) to
IN THE EXTREMELY RARE CIRCUMSTANCE WHERE THE BATTERY
IS DAMAGED AND ELECTROLYTE COMES IN CONTACT WITH EYES,
™
™
mask. Before washing the mask, remove the valve cap
10
™