Hendi PROFI LINE 229026 Bedienungsanleitung Seite 7

• Press the ON / OFF button to start the opera-
tion, the LED display will show the default time
Time setting:
• Now, you can press button + or - to increase or
decrease operation time. (Range: 00:30 ~ 24:00,
interval is 30 minutes).
• The setting time will be stored automatically
within few seconds.
Temperature setting:
• Press TEMP / TIME button once to check the
temperature setting, you can also press button
+ or - to increase or decrease operation temper-
ature setting. (Default temperature: 70°C, range:
35°C ~ 75°C, interval is 5°C).
• The setting temperature will be stored automat-
ically within few seconds and return to display
remaining time on the LED display.
Switch to STANDBY mode
• Press ON / OFF button to turn to STANDBY mode. All the buttons will go out except the ON / OFF button.
And the LED display will be shown as " 00 00 " in white.
Time setting end up
• When the setting time counts down to 00:00, the
heating elements stop working first. The cool-
ing fan will still continue running for about 10
seconds and 20 times of "beep" sound from the
buzzer will be heard to remind the user the oper-
ation is finished.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning.
Cleaning
• Clean the inside and outside of the appliance,
trays, bottom pad and door with luke-warm wa-
ter, a mild detergent and a soft cloth. Do not clean
the fan part.
• Dry all parts with a dry cloth before storing the
appliance.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
"10:00" (10 hours). All buttons on the control pan-
el will be lighted up in blue.
• Then, the appliance will start operation and re-
maining time will be shown on the LED display.
The fan at the rear side of the appliance will start
rotation.
• If you want to check the temperature that was
set, press TEMP / TIME button once and the set
temperature will be shown on the LED display.
• During the operation process, you can check
or change the time and temperature setting by
pressing the TEMP / TIME button. And then press
button + or - to increase or decrease the temper-
ature and time setting.
• 'End' will be shown on the LED display and the
appliance is in STANDBY mode.
• Unplug the appliance and wear gloves (not in-
cluded) if necessary to take out the food.
• Occasionally clean the fan unit with a vacuum
cleaner.
• Note! To avoid damaging the appliance, do not
clean the appliance with aggressive chemical or
abrasives
• Store the appliance in a cool, clean and dry place
and out of reach of the children.
EN
7