cecotec DRUMFIT WAYHOME 1800 RUNNER SPRINT Bedienungsanleitung Seite 57

Box content
- DrumFit WayHome 1800 Runner Sprint Treadmill
- Tools for assembly
- Instruction manual
3. APPLIANCE ASSEMBLY
Important
This appliance weighs more than 40 kg. It is recommended that at least 2 people assemble
the appliance.
Step 1. Mounting the front uprights
- Unfold the front uprights as shown in the figure. Align the bolt holes of both uprights with
the base frame.
- Insert a hexagonal bolt (S1) on both sides and tighten them with the Allen key (S11) provided.
- Next, insert a hexagonal bolt (S2) and a curved washer (S3) at the rear part and tighten
them with the Allen key (S11). Fig. 2
Attention
Do not fully tighten the bolts in step 1 until you have completed step 2.
Step 2. Assembling the handlebar
- Fit the handlebar (C) to the front uprights, align the screw holes at the rear with the screw
holes in the front uprights.
- Tighten the upper handlebar (C) with a hexagonal bolt (S2), a plain washer (S4), a hexagonal
bolt (S2) and a curved washer (S3) on both sides. Tighten the assembly with the Allen key
(S11) provided. Fig. 3
Important
Before fitting the handlebar, make sure that the connecting cable inside the right-hand upright
is securely connected, and be careful not to pinch it.
Step 3. Assembling the console
Install the console (B) on the upper handlebar (C) and tighten it securely with one ST4 screw
(S7) and two hexagonal bolts (S2). Fig 4.
Important
After installation of the console, insert the power cable and secure it with the locknut.
Step 4. Installing the rear trim covers
- Tighten the rear trim covers (H) to the frame with two screws (S5) on both sides.
DRUMFIT WAYHOME 1800 RUNNER SPRINT
ENGLISH
57