JOBOBIKE SAM Bedienungsanleitung Seite 35

Fehlercode Definition
25 Torque signal Error
Speed signal of the torque sensor
26
has an error
27 Over current from controller
30 Communication problem
Lösung
1. Check that all connections are connected correctly.
2. Please connect the pedelec to the BESST system to see if torque can be read by
the BESST tool.
3. Use the BESST Tool to update the controller to see if it resolves the problem, if not,
please change the torque sensor or contact your supplier.
1. Check that all connections are connected correctly.
2. Please connect the pedelec to the BESST system to see if speed signal can be read
by the BESST tool.
3. Change the Display to see if the problem is solved.
4. Use the BESST Tool to update the controller to see if it resolves the problem, if not,
please change the torque sensor or contact your supplier.
Use the BESST tool to update the controller. If the problem still occurs, please change
the controller or contact your supplier.
1. Check if all connections on the pedelec are correctly connected.
2. Use the BESST Tool to run a diagnostics test, to see if it can pinpoint the problem.
3. Change the display to see if the problem is solved.
4. Change the EB-BUS cable to see if it resolves the problem.
5. Use the BESST tool to re-update the controller software. If the problem still occurs,
please change the controller or contact your supplier.
35